Why Is The Aluminum Composite Panel Deformed?

Nov. 20, 2018
Share:

The high quality aluminum composite panel is a very common decorative material that is used extensively in today's society. The material of the aluminum composite panel has always been good, but occasionally there will be some minor problems.

Deformation and drumming of the surface of the aluminum composite panel:

There are many reasons for the deformation and drumming of the surface of the aluminum composite panel. In the past, this kind of quality problem appeared in the construction. We thought it was the quality reason for the plate itself. Later, after the concentrated analysis of everyone, the main problem was on the base plate with the aluminum composite panel attached, followed by the aluminum panel, the quality of the board itself.

The base materials recommended by dealers are mainly high-density boards, wood boards and the like. In fact, when such materials are used outdoors, their service life is very fragile. After wind, sun, and rain, the deformation will inevitably occur. Since the base material is deformed, the aluminum composite panel as the surface layer is also deformed. It can be seen that the ideal outdoor base material should be rust-proofed, and then the angle steel and square steel tube are formed into a skeleton. If conditions permit, it is more desirable to use aluminum profiles as the skeleton. The skeleton made of this kind of metal material is not much higher than the wooden keel and high-density board, which can ensure the quality of the project.

At the same time pay attention to the maintenance and care of decoration aluminum composite panels. When cleaning the aluminum composite panel, it should be cleaned according to the habit of the aluminum composite panel.

Aluminum Composite Panel