Profile Aluminum Square Production Process

Jan. 16, 2019
Share:

The caliber of profile aluminum square is derived from the high level of aluminum contained in its own raw materials. On the one hand, it is derived from the technical management in its production process, but regardless of what aluminum profile, it must listen to an aging process, that is, in the manufacturing procedure. Every link has controller management.

The Wooden Aluminum Composite Panel Supplier tells you the aging process in the production of aluminum profiles:


1. Profile aluminum square fold has to maintain the exact same aging furnace, the temperature controller temperature in the furnace is involving 190-220, heat preservation for three to four hours, the hardness requirement is higher for five or more hours, and the blower is blown immediately after the furnace is blown 20 After a minute of heating, the quality inspector checks the hardness.

2. When the aging insulation profile is not full, the 1-2 frame regular profile (wall thickness under 2.0mm) may be put at the exact same furnace, and the aging procedure is performed according to the heat insulation profile procedure.

3. When the hanging material is put into the furnace, the profile end and the air guiding port are controlled within 80~100mm.

4. When the temperature in the furnace reaches the required temperature of the process, the aging worker measures the actual temperature in the furnace with a glass tube thermometer every 30 minutes and makes the original record.

If you need Fire proof Aluminum composite panel and PE Coated Aluminum Composite Panel. Welcome to inform us.


Wooden Aluminum Composite Panel Supplier